Resolved the issue of that RXSR not starting properly when working with RXSR (RXSR as slave receiver) in redundancy mode. Fixed the issue that Vario updating is slow for GR6 & GR8. Fixed the issue that telemetry lost alarms from time to time.Ģ. Add Acc-X /Y/Z sensor and Angle output for SRx receivers.ġ. Add SBUS 24-channel mode (ETHOS to be updated to work with).ģ. Optimize the gyroscope algorithm to improve the adaptability with models under strong vibration.Ģ. Note: For ETHOS-based radio only, please update the ETHOS to v1.1.2 or above to use.ġ. Improve FBUS baud rate and adapt to the latest Xact servo update. Enter the self-check mode through configuration, which facilitates operation and improves system security.Ģ. ISRM-S-X10E → (Horus X10 EXPRESS & X10S EXPRESS)įixed the issue of telemetry loss and receiver reboot caused by using the ADV sensors together with Xact servos.ġ. ISRM-N → (Taranis X9 Lite & QX7 ACCESS & QX7S ACCESS) Note: Please make sure the involved Receiver or Transmitter in using have been both upgraded with this update or later version.Ĭompatibility | ISRM Modules & ACCESS Radios Fixed the issue of no PWM output caused by abnormal conditions in the S.Port link such as unregular data sent by unknown devices in connection or exceeding the limitation of devices connected in the S.Port link (>27 units). * The suggested ACCESS RSSI is 32 for Critical Alarm and 35 for Low Alarm.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |